Need help?Do you have a question about the ESAB ESABMig 300i and is the answer not in the manual?
General| Input Frequency | 50/60 Hz |
|---|---|
| Wire Diameter | 0.8-1.2 mm |
| Efficiency | 85% |
| Power Factor | 0.93 |
| Output Current Range | 30-300 A |
| Cooling | Air-cooled |
| Protection Class | IP23 |
Describes the power module, responsible for converting mains power to welding voltage via dual forward inverter.
Details the 15AP1 power board, covering charging, gate driver, switching, and protection circuits.
Details the 20AP1 control board, which monitors and controls all power source functions.
Describes how faults are documented in the fault log and how to read them via ESAT.
Provides a summary table of fault codes and the units they affect.
Details fault codes specific to the power source unit, including descriptions and actions.
Details fault codes specific to the AC unit, including descriptions and actions.
Details fault codes specific to the wire feed unit, including descriptions and actions.
Provides instructions and diagrams for checking the 15AP1 power board components and resistance values.
Details how to check the diode modules and NTC resistors on the 15AP2 secondary board.
Instructions for checking IGBT modules on the 18AP2 AC power board, including resistance and diode tests.
To Next Page