What to do if my ESAB Welding System has no arc?
If your ESAB Welding System has no arc, first, ensure the electrical power supply switch is turned on. Check that the display is on to confirm the power source has power and that the setting panel is displaying correct values. Also, verify that welding and return cables are correctly connected and inspect the electrical power supply fuses.
How to troubleshoot MMA welding problems with ESAB Renegade ES 210i?
If you are experiencing MMA welding problems with your ESAB Welding System, ensure the welding process is set to MMA. Verify that the welding and return cables are correctly connected to the power source and that the return clamp has good contact with the workpiece. Confirm that you are using the correct electrodes and polarity (check the electrode packaging for polarity information). Also, check that the correct welding current (A) is set and adjust the Arc Force and Hot start settings.
Why does the thermal protection trip frequently on my ESAB Welding System?
If the thermal protection trips frequently on your ESAB Welding System, ensure that the recommended duty cycle for the weld current has not been exceeded. Also, check that the air inlets or outlets are not clogged. Clean inside the machine according to routine maintenance procedures.
How to fix TIG welding problems on ESAB Welding System?
If you are experiencing TIG welding problems with your ESAB Welding System, ensure the welding process is set for Live TIG as necessary. Check that the TIG torch and return cables are correctly connected to the power source. Make sure that the return clamp has good contact with the workpiece and that the TIG torch lead is connected to the negative welding terminal. Also, ensure that you are using the correct shielding gas, gas flow, welding current, filler rod placement, electrode diameter, and welding mode on the power source.
What to do if welding current is interrupted during welding with ESAB Welding System?
If the welding current is interrupted during welding with your ESAB Welding System, check whether the Over Temperature LED (Thermal Protection) on the setting panel is on. If the issue persists, continue troubleshooting as if it were a "No Arc" fault.
General| Frequency | 50/60 Hz |
|---|---|
| Output Current Range | 5 - 210 A |
| Weight | 16.8 kg (37 lbs) |
| Protection Class | IP23 |
| Input Voltage | 230 V |
| Duty Cycle | 60% at 210 A |
| Process | SMAW/GTAW |
| Power Factor | 0.93 |
| Efficiency | 85% |
| Phase | Single Phase |
To Next Page