4 INSTALLATION
0444 408 331
- 13 -
© ESAB AB 2020
4 INSTALLATION
The installation must be carried out by a professional.
WARNING!
When welding in an environment with increased electrical danger, only power
sources intended for this environment may be used. These power sources are
marked with the symbol .
4.1 Lifting instructions
CAUTION!
To avoid personal injury and/or equipment damage, lift using method and attachment
point shown here.
Order number for lifting eyelet can be found in chapter "ACCESSORIES".
NOTE!
If another mounting device is used, this must be electrically insulated from the wire
feed unit.
CAUTION!
If equipment is placed on a surface that slopes more than 10°, toppling over may
occur. Personal injury and/or significant damage to equipment is possible.
To Next Page
Loading...
