Escea D Series - Page 6

6

B4 
To set the room temperature, press the plus (+) or minus (-) symbols repeatedly unl the display is showing the
desired temperature.
B5 Fan Boost
The re has four FAN SPEED sengs. The rst low fan speed will run automacally on start-up. The second and
third fan speed will automacally switch on or o with the increase or decrease of the set temperature, and the
forth fan speed is an oponal FAN BOOST speed, which can be accessed on your remote menu screen. Pressing
the FAN BOOST toggle buon will increase the fan speed to its maximum and help transfer the maximum
amount hot air form the re into the room. When this mode is not on, the re will sll use fan speeds one, two,
and three.
B6 
Pressing the FLAME EFFECT symbol will run the replace on its lowest seng. The replace will sll produce
some amount of heat in this seng and the room fan will connue to operate.