Escort MAX 3 - Preference Settings Configuration; User Mode and Display Settings; Alert and Speed Settings; Meter Mode and Audio Customization

10 | Page
User Mode
Advanced*
Access and customize all Preferences
Novice
Access and customize Units and Display Color
only, all other Preferences are set to factory
defaults
NOTE: Switch back to Advanced Mode to view all
Preferences.
Pilot Mode
Scanning*
Displays scanning bar and the selected SEN mode
Full Word
Displays only the selected SEN mode
Display Color
Blue* / Green / Red /
Amber
Set color to match your vehicle’s dash display
Speed Display
On*
Displays current speed
Off
Displays vehicle voltage instead of speed
Cruise Alert
20 mph*
Offers only double beep alert tones below the
specified speed
Off / 20-160 mph
Over Speed
70 mph*
Alerts when the specified speed is exceeded
Off / 20-160 mph
Meter Mode
Standard*
Single band with signal strength bar graph
Spec
Single band with numeric frequency
Expert
Multiple bands with signal strength bar graphs
Simple
Simple messages replace alert band and signal
strength bar graphs:
Caution (if traveling below Cruise Alert limit)
Slow Down (if traveling above Cruise Alert limit)
Tones
Standard*
Standard alert tones
Mild
Mild doorbell chime alert tones
AutoMute
Low / Med* / High /
Off
During an alert, automatically reduces audio to
selected volume level
AutoLearn
On* / Off
Automatically stores and locks out false alerts
Units
English* / Metric
Units for distance and speed
Language
English* / Español
Language for voice and text
Voice
On* / Off
Voice announcements
GPS Filter
On* / Off
Enables GPS Filtering of stored false alerts
AutoPower
Off / 1 Hour / 2 Hours /
4 Hours*/ 8 Hours
Powers down unit after specified time
NOTE: If AutoPower is enabled, to save screen life
the display screen goes blank after 30 minutes
without moving. Display screen will turn on
automatically after you reach 10MPH
Band Enables
Default*
Default Band Enables
Modified
Band Enables have been modified from their
default settings
Repeatedly press SEN to cycle through
Band Enables
Press + or – to change the selected Band Enable
on or off
X Band
On* / Off