Problem Explanation/Solution
Detector beeps briefly at the same An X band motion sensor or intrusion alarm is located
location every day, but no radar within range of your route. If you have AutoLearn
source is in sight. enabled, the factory default setting, then ESCORT
Max 360 will store this signal after about 3 passes
and no longer alert to it.
Detector did not alert when a VASCAR (Visual Average Speed Computer and
police car was in view. Recorder), a stopwatch method of speed detection,
may be in use.
Officer may not have radar or laser unit turned on.
Detector’s audible alerts become Detector is in AutoMute mode. See “AutoMute” in the
softer after the first few alerts. Settings & Preferences section for details.
The power-on sequence reoccurs A loose power connection can cause ESCORT Max
while you are driving. 360 to be briefly disconnected and will retrigger the
power-on sequence. Check all connections.
You wish to restore the factory Press and hold the BRT and MRK buttons while
default settings. powering on the detector. A “Restored” message will
display, acknowledging the reset.
The device will not turn on. Check that vehicle ignition is on.
Check all connections.
The display feels warm. It is normal for the device to feel warm.
The display is blank. ESCORT Max 360 is in Dark mode. Press the BRT
button to adjust the brightness.
The following accessories and replacement parts are
available for ESCORT Max 360:
• Combo SmartCord
• DirectWire SmartCord
• Laser ShifterPro System
• StickyCup Magnet Mount
• Travel Case
Parts & Accessories
Troubleshooting
To Previous Page
Loading...
