Getting Started
What’s Included
• Radar/laser detector unit
• StickyCup windshield mount
• SmartCord power adapter
• Quick Reference Guide
• Soft-shell case
Mounting Tips
• Center on windshield between driver and
passenger.
• Ensure clear view of road ahead and sky above.
• Avoid windshield wipers and heavily tinted areas.
To mount in your vehicle:
1 Remove backing from StickyCup mount.
2 Firmly press StickyCup onto windshield and flip
locking clamp to secure.
3 Slide PASSPORT Max mounting slot onto mounting
bracket and push back gently to lock into place.
4 To adjust view, loosen thumb wheel and adjust
angle of mounting bracket. Tighten thumb wheel
to secure.
5 To remove detector, press mount release button on
top of PASSPORT Max and slide device off
mounting bracket.
6 To remove mount from windshield, release locking
clamp and pull tab on top of StickyCup.
StickyCup Care Instructions
To clean StickyCup, simply rinse under warm water,
gently wipe off any debris and allow to air dry.
To begin using PASSPORT Max:
1 Plug small end of SmartCord into modular jack on
PASSPORT Max and large end of SmartCord into
your car’s lighter/accessory socket.
2 PASSPORT Max should power on automatically. If
not, press the device’s power button.
3 Upon initial power-up, PASSPORT Max will ask you
to confirm some basic settings and preferences.
Press MRK button to scroll through and OK these
settings (or press VOLUME + or – to edit).
NOTE: You can easily access and customize all of your
settings and preferences by pressing and holding the
MRK and SEN buttons. See the Settings & Preferences
section for details.
4
StickyCup
Locking Clamp
Thumb Wheel For
Angle Adjustment
Mounting Bracket
Mini USB Jack
Connects to your computer via USB A/mini B
cable for downloading software updates
Modular Jack
Connects to SmartCord for powering
your device
Earphone Jack
Connects to optional 3.5 mm
stereo earphone.
To Next Page
Loading...
