User’s Guide User programming: An introduction
C.5
4 Station audibles
The station audibles programming provides control of the following audible items.
Note: Only the third setting, message ring, is applicable to the ESI Cordless Handset.
1 Station ring tone
You can select from six possible tones to help distinguish it from other nearby ringing phones.
Press
or to select a tone, then press # to accept it.
2 Station ring volume
Press
and to set the desired ringer volume (range: off to high), then press # to accept it.
Note: (48-Key and 24-Key Feature Phones only)
If the ringer volume is turned off, the status indicator lamp will not “flutter” when an incoming or
recalled call is presented to the phone (see “Status indicator lamp,” page D.8).
3 Message ring
When enabled, this feature will periodically generate a short ring tone at your station as an additional
alert that you have new messages.
Your phone has a secondary ring tone you’ll hear (if your system has been programmed accordingly
by your Installer) when call waiting occurs — i.e., a second call rings in for you while you’re already on
another one — on live-ring calls. The following two parameters let you adjust how it sounds.
5 Password
1 Enter new password
Your password may consist of 2–8 digits followed by # (0 cannot be the first digit). Entering only 0 as the
password will turn off the password requirement.
2 Delete current password
Resets the password to the default password.
3 Hear current password
Displays and plays back the current password.
4 Password security level
Selection Result
0 No password required for access from any phone
1 Password required only for remote access, either off-premises or from other stations within the system
2 Password always required
To Next Page
Loading...
