ESI Feature Phone operation User’s Guide
E.14
Paging
Your ESI system can be programmed to allow paging through an overhead paging system and/or paging through
some (if page zones have been created) or all of the system’s Feature Phone speakers.
Overhead paging
Station number 199 is designated as the overhead paging port. If the ESI system has been connected to an
overhead paging system, you can page by dialing 1 9 9 and making your announcement after the tones. If
you frequently page, assign 1 9 9 to a programmable feature key (see p. C.2).
Paging through phones
Press PAGE 0 to page through all of the ESI Feature Phone speakers. Press PAGE and then 1, 2, or 3 to
access a programmed paging zone. (See the administrator for a list of page zones.) The Installer may have
added an overhead page system to one or more of these page zones.
Note: Phones in use or in do-not-disturb mode will not carry a page through their speakers.
To page for pickup of an outside call
To page someone to pick up an outside call:
1. Place the call on hold by pressing HOLD.
2. Verify the line number from the display.
3. Page the person and announce the hold location for retrieval. For example:
“Sarah, you have a call on Line Two — Sarah, Line Two, please.”
Call pickup
From your station, you can answer a call ringing at another station or department by pressing
(labeled P/UP, for
pickup) and then either dialing the extension or (if the destination is programmed into one of your keys; see
“Programmable feature keys,” p. C.2) pressing the station key for the ringing station.
During night mode (see page F.15), if a night bell is in use instead of the night auto attendant, press
0 to
access the ringing outside call.
To Next Page
Loading...
