quite low e.g. 15c. Press the
►►button to move on to P3.
7. Use the +/- buttons to set your P3 start
time (this is when you want your
heating to be ON again, then press the
►►button to move on to the
temperature for P3.
8. Use the +/- buttons to set your P3
temperature, then press the
►►button to move on to P4.
9. Use the +/- buttons to set your P4 start
time (this will be when you want your
heating to go OFF for overnight), then
press the ►►button to move on to
the temperature for P4.
10. Use the +/- buttons to set your P4
temperature, remember this is an OFF
program so you may want to set it
quite low e.g 15c. Press the
►►button.
11. If you are using 7Day or 5-2Day
Schedule, press the ALL DAY button to
move on to the next day or weekend
and follow the steps above.
Using the COPY function
When using 7Day mode, you can copy an entire
day’s programs onto another day by following
these steps.
1. Use the MODE button to select AUTO.
2. Tap the COPY button. You will see a
solid MO (Monday) and a flashing TU
(Tuesday) at the top of the screen. The
solid day is the day you are copying
from, and the flashing day is the day
you are copying to.
3. Choose the day to copy from by
tapping the ALL DAY button & choose
the day to copy to by using the +
button.
4. Press COPY to confirm and you will see
SET on the display to acknowledge the
change in programming.
To Next Page
Loading...
