Technical Manual
Kongsberg XE and i-XE Systems
with GC900sm Controller
This manual contains a technical description of the
GC900sm Controller based Kongsberg Cutting System.
The purpose of this manual is to offer documentation necessary for service personnel.
Note
We remind you that only the Esko-Graphics staff, or persons
having received an appropriate training, are allowed to handle,
manipulate or do running repairs on the machines.
______________________________________
A Publication of: Esko-Graphics Kongsberg AS
Copyright © 1984-2009 Esko-Graphics Kongsberg AS.
This copyright does not indicate that this work has been published.
All rights strictly reserved. Reproduction or issue to third parties in any form
whatever is not permitted without written authority from the publisher.
Esko-Graphics reserves the right to change specifications without notice.
Document number: D3018
Status: 091012
Esko-Graphics Kongsberg AS
www.esko.com
P.O.Box 1016, N-3601 Kongsberg, Norway
Tel: +47 32 28 99 00 Fax: +47 32 28 85 15 / 32 28 67 63
To Next Page
Need help?
General
