TP Screw (2.3x12mm)
136mm
wing tip
Make sure hinges are
mounted in the same line.
1mm
Aileron
Trailing
edge
Make sure they are in
the right position while
installing.
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
3mm
1.5mm
Rod (2x300mm)
Clevis
Washer(3x15mm)
Washer
Lock Nut (3mm )
Screw (3x50mm)
Screw (2x10mm)
8
6
2
2
2
4
2
2
2
2
Clevis
Rod (2x300mm)
Retainer
TP Screw (2.3x12mm)
Wooden Block(20x20x8mm)
Servo tray(68.5x56.5x2mm)
Pin hinge(24x24mm)
Screw (3x50mm)
Washer(3x15mm)
2
Washer(3x15mm)
Lock Nut (3mm )
6
Pin hinge(24x24mm)
The position of the control horn in the
flap for mid wing will be.
Secure the servo,install the nylon control horn
and connect the linkage.
Glue the pin hinges to the aileron with C A instant glue.
Keep some space about 1mm width between
the trailing edge and aileron.
Glue the aileron to the main wing with C A glue.
7
6
8
9
10
2
Accessory list for the coming installation steps.
4
Pin horns
Ply (35x16x6mm)
4
2
5
Air switch
Pin horns
52mm
115mm
3mm
3mm
8mm
8
Hatch hinges mount
4
Joints
48
48
Screw (3x10mm)
Nut (3mm )
90
Washer(3x6mm)
12
Nut (2mm )
6
Washer(2x5mm)
Screw (3x10mm)
Washer (3x6mm)
Nut (3mm )
Washer (3x6mm)
Entad
32
32
Screw (3x10mm)
Nut (3mm )
64
Washer(3x6mm)
3
Screw (2x25mm)
1
Pin hinge (36x20x1mm)
Recommended optional retract installation process.
All the accessories in the coming process are
optional only.Customer should purchase them
from our local distributor.
Trim the shaded portion along the PVC parts carefully.
Epoxy the PVC parts to the fibre plate and cut
it into two equal parts as below.
According to the hatch hinges mount holes drill holes to appropriate
position in the gear door and assemble the hatch hinges mount to
the gear door as below.
Notice the direction of the screw when assemble
the hatch hinge mount.
01
02
03
04
18
Accessory list for the coming installation steps.
All these parts below are for option .
To Next Page
Loading...