Celebrating over 30 years of excellence in manufacturing ultrasonic cleaning
equipment, electropolishing equipment and associated chemistries
ESMA, Inc.
P. O. BOX 734 * SOUTH HOLLAND, IL 60473 * (800)-276-2466 * FAX (708)331-8919
7. OPERATION
The basic principle of operation is the enhancement and
acceleration of the cleaning action through ultrasonic
cavitations. Instruments, or parts to be cleaned, are
placed in the basket (or cassette racks) and lowered into
the tank.
NEVER PLACE PARTS DIRECTLY ON THE BOTTOM OF THE TANK.
The baskets and cassette racks have rubber supports to keep parts off bottom
of tank.
8. PROCEDURE
1. Turn main power ON
2. Turn RUN-STOP switch to RUN. (Should remain in RUN position at all
times.
3. Set FILL/CLEAN switch to FILL.
4. Verify that the metering pump inlet supply is inserted into a gallon jug
of an approved Esma cleaning concentrate (see section on cleaning
agents).
5. Lower basket with instruments, or parts, on support rack.
6. Close cover.
7. Push START button and water will enter the tank for 90 seconds.
8. At this point more instruments (or parts) could be added when
available, or move FILL/CLEAN switch to CLEAN, push START button
and the cleaning program will automatically proceed through the cycle
as follows:
To Next Page
Loading...