20
Specifications
Restoring factory settings
Settings are retained even if the power plug is disconnected.
Follow these procedures to restore all settings to their factory
defaults and clear the unit's memory.
1 Turn the unit o.
If the unit is on, press the POWER button to turn it off and wait
for more than 30 seconds.
2 Press the POWER button while holding down the
MENU button.
When “Setup CLR” (clear settings) appears on the display, release
the MENU button.
Note about condensation
If this unit is brought from a cold outdoor environment into a
warm room, or the heater has just been turned on in the room
where it is located, for example, condensation might occur on
operating parts or lenses, resulting in improper operation. If this
occurs, leave the unit on and wait 1–2 hours. This should enable
normal playback.
Troubleshooting (continued)
Digital audio inputs
RCA connectors ..........................................2 pairs (L/R)
Input level ...............................................0.5 Vp-p
Input impedance ............................................75 Ω
Input signal format ....................................32–192 kHz
16-bit to 24-bit
Linear PCM (IEC 60958 format)
DSD (DoP format)
Optical digital connector ........................................... 1
Input level .........................−24.0 dBm to −14.5 dBm (peak)
Input signal format ....................................32–192 kHz
16-bit to 24-bit
Linear PCM (IEC 60958 format)
DSD (DoP format)
USB port ....................................................1 (Type B)
Input signal format ..................................44.1–384 kHz
16-bit to 32-bit
Linear PCM
2.8/5.6/11.2MHz DSD
ETHERNET port ...........................................1000BASE-T
Input signal format ..................................44.1–384 kHz
16-bit to 32-bit
Linear PCM
2.8/5.6MHz DSD
Supported file formats
DSD lossless ............................DSF, DSDIFF (DFF), DoP
PCM lossless ........... FLAC, Apple Lossless (ALAC), WAV, AIFF
Compressed audio ..................MP3, AAC (m4a container)
USB DRIVE port ................FAT32; USB 2.0 or faster recommended
Digital audio output
RCA connector ..................................................... 1
Output level .................................0.5 Vp-p (into 75Ω load)
Output impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .75 Ω
Output signal format ...................................44.1–192 kHz
16-bit to 24-bit
Linear PCM (IEC 60958 format)
DSD (DoP format)
To Next Page
Loading...
General