10
(7) Adjust the tilting angle of camera by adjusting the screws on both side.
(8) Loosen the screw on the back using hex key provided to adjust the pan angle. Screw it firmly
when you done.
(9) Once completed, turn on the power from the breaker and the lighting camera will power up.
Wait for 1 minute for camera to connect to internet.
(10) The LED light will be at its full brightness when initial start due to the regulation.
You could adjust the brightness to prefer level once the camera has setup completed.
(11) It is recommended to install the lighting camera at the at surface under the eave or position to
have better waterproof protection.
7
9 10
11
on
8
GUARDCAMDECO QUICK START GUIDE.indd 8 12/03/2018 14:35:11
To Next Page
Loading...
