Malfunction Display
Should a malfunction occur, the display shown in figure 16
will appear, even if the unit is in ‘standby’ mode. The
display will show an error cost and a description. For error
codes, please refer to the table below:
Factory Setting
Stand-by
status: Outlet water temperature:
Actual tested value,not adjustable
Stand-
by status:Target/setting water tempertaure
Running status: Outlet water temperature
Actual tested value,not adjustable
Running status:Target /setting water temperatur
e
Actual tested value,not adjustable
main menu: Mode select/Unit status
Actual tested value,not adjustable
Actual tested value,not adjustable
Actual tested value,not adjustable
Actual tested value,not adjustable
Actual tested value,not adjustable
Actual tested value,not adjustable
3.2
Defrost
in
temperature
3.3
Defrost
out
temperature
Actual running record, not adjustable