SECTION 5 - COMMISSIONING
A note on safety:
No additional safety hazards are present with ESS 2000® Skirting other than normal
conveyor belt dangers.
In particular:
Beware of moving conveyor belts.
Beware of pinch points
Do not attempt to install, maintain or disassemble any part of a conveyor belt
without first isolating and tagging the conveyor drive.
1. Following site safety and start-up procedures, start conveyor belt and run under
normal conditions for 10 minutes. Observe ESS 2000® Skirting and look for
material leakage.
WARNING: BEFORE PROCEEDING WITH COMMISSIONING, ENSURE THAT THE
CONVEYOR BELT DRIVE IS FULLY ISOLATED AND LOCKED OUT.
2. Lockout / tagout all power to conveyor belt and conveyor accessories.
3. Adjust skirting rubber by following step 7 in Section 4.1.
4. Remove danger tags and return conveyor to service, following plant
procedures.
5. Start conveyor and run under normal conditions.
To Next Page
Loading...