Page 26 PROGRAMMING
Programming via e-stant software
It is possible to program Helpy Compact via computer by using the USB/serial
proprietary cable and the dedicated e-stant software.
e-stant software also allows to:
- update the firmware of the Helpy Compact
- customize the messages of the Helpy Compact
- set a micro SD card to use for programming, customizing the messages and
updating the firmware of the Helpy Compact.
e-stant can be downloaded at the following link:
https://www.esse-ti.it/en/download/software-request
Programming via micro SD card
The micro SD card properly set allows to:
- program the Helpy Compact
- update the firmware of the Helpy Compact
- customize the messages of Helpy Compact.
To use of the micro SD card see the relating instructions.
To Next Page
Loading...
