5
17
4. INSTALLATION INSTRUCTIONS
CO ALARM
Building regulations require that whenever a new or replacement fixed solid fuel or wood / biomass
appliance is installed in a dwelling, a carbon monoxide (CO) alarm must be fitted in the same room
as the appliance, in accordance with BS EN 50292:2002. Please consult Document J of the Building
Regulations for detailed guidance. The installation of an alarm must not be considered a substitute
for either installing the appliance correctly, or ensuring regular servicing and maintenance of the
appliance and chimney system.
UNPACKING THE APPLIANCE
The stove comes bolted and strapped to a pallet, for simple and secure transportation. To unpack,
first remove the strapping and packaging. Then remove the two bolts holding the stove to the pallet,
using a 10mm spanner. Locate the four Height Adjusting Bolts supplied with the appliance, and
insert them from below into the same four holes in the feet of the stove, using a 13mm spanner.
These can then be individually tightened / loosened as required, to level the stove on an uneven /
sloping hearth. Whilst heat-treated, the pallet has been produced from timber that is appropriate
for use as kindling, so can be broken up and chopped, for this purpose. Finally, dispose of the
remaining packaging responsibly.
To Next Page
Loading...
