Esselte LEITZ ImpressBIND 140 - Binding; Setting up the Machine; Determining the Correct Spine Width; Placing Pages in the Binding Cover

6
Binding
Setting up the machine1.
Carefully place the machine on a stable surface.•
Move the binding lever •
A
upwards.
The machine is now ready to use.•
Determining the correct spine width2.
Raise the measuring device •
E
and place the pages to be bound
below it.
Let the measuring device down again and read off the recommended •
spine width from the scale.
Take out the pages.•
The spine width is indicated on the metal strip in the binding cover.
Number of pages
(80 g/m²)
Spine width
of binding cover
15–35 3.5 mm
36–70 7 mm
71–105 10.5 mm
106–140 14 mm
Placing pages in the binding cover3.
Straightenthepagessothattheedgesareush.•
Insert the pages into the binding cover.•
Make sure that the space between the pages and the upper and lower •
edge of the binding cover are identical.
Binding4.
Make sure that the binding lever •
A
is pushed up as far as it will go.
Place the binding cover in the binding tray.•
Caution, danger of crushing ngers/hands!Whenbinding,hold
the binding cover with one hand and the lever with the other hand and
keep other persons away from the machine.
Press the binding lever •
A
downfourtimes.Whiledoingso,movethe
leveronlyupwardstotherststop.
Move the lever fully upwards again and remove the bound book.•
A de-binder, 7448-00-00, is available as a separate item. You can use this
accessory to reopen a bound book up to three times in order to remove or add
pages.

3
4
1
1
2
2

