GB
7. JAM
The program is intended for making of jam or marmalade from fresh fruits. It is not possible
to set the size in this mode.
8. DOUGH PREPARATION
The program is intended for kneading/stirring and rising of the dough without baking. You
may use various foods for different types of break to make the dough (e.g. bread rolls,
pizza etc.). If you intend to bake subsequently, it is necessary to set the corresponding
weight, desired colour and type of program. It is not possible to set the size in this mode.
9. ULTRA FAST
The program is intended for quick baking of white, wheat and rye bread. This setting
shortens the time necessary for kneading/stirring, rising and baking to minimum. Bread
baked in this mode is smaller and has a thicker centre. It is not possible to set the size
of the loaf in this mode. For this program it is necessary to use water (or other liquid
ingredients) with temperature 48-80 °C.
10 BAKING
The program is intended for baking of brown bread, cakes or meatloaf. The program is
preset for 10 minutes. The length of baking can be adjusted according to your needs by
pressing the TIME button. The longest setting is 1 hour. It is not possible to set the size of
the loaf in this mode.
11. GLUTEN-FREE
This program is intended for gluten-free bread preparation. It is not possible to set the loaf
size in this mode.
12. HOME
This program is intended for individual setting of all the stages of bread preparation. The
range of time setting in each individual stage (i.e. kneading H1, H2, rising K1, K2, K3,
baking, heating) is described in the “program stages” table. It is not possible to set the size
of the loaf in this mode. The process of programming is the same in each individual stage.
- press the CYCLE button, the display will show (e.g. H1),
- by pressing the TIME button, set the length of the cycle (see table “program stages”),
- conrm by pressing the CYCLE button.
Repeat the process until you set all the stages of the bread preparation. After setting press
the START/STOP/PAUSE button which will launch the set program.
IV. BREAD MAKER FUNCTION
Time setting (actual time)
Remove the battery cover on the bottom of the device, insert the batteries according the
+/- signs, remove the isolation tape from the battery compartment and replace the cover.
The display shows 12:00. The clock has a 12-hour cycle.
- Switch the main switch A6 into position I, an audio signal will sound (1 beep) a the
display will light up,
- after pressing and holding the
CYCLE
button for 3 seconds
the display will show SET
TIME and number 12 will start flashing,
- pressing the TIME button again or holding it down you may set the hour. The sign AM or
PM show the morning or afternoon time,
To Next Page
