GB
- press the CYCLE button and the 00 number will start flashing,
- pressing the TIME button again or holding it down you may set the minutes.
- confirm by pressing the CYCLE button.
The audio signal function will be active:
- if any of the program buttons is pressed (1 short or long beep), the display will light up
for approx. 10 seconds.
- during second kneading cycle with programs 1-KLASIK, 2-WHOLE GRAIN, 3-TOAST,
4-QUICK, 5-SWEET, 6-CAKE, 9-SUPER QUICK, 11-GLUTEN-FREE and 12-HOME for
signalization that cereals, fruit, nuts or other ingredients may be added (10 x beep),
- when the set program ends (10 x beep),
- when the 1-hour heating ends (1 x beep),
- when the safety features are activated (constant beep)
- during 1. hour heating-up every 5 minutes (5 beeps) and after the heating-up is finished
(1 beep).
Safety features
- If you wish to use the bread machine right after previous baking and if the temperature
of the inner space of the device is not too hot (over 45 °C), after pressing the START/
STOP/PAUSE button the display will show HHH and a constant audio signal will sound
(beep). The device can not be turned on. Open the lid or take out the baking form
and wait for the device to cool off. The audio signal can be cancelled by pressing the
START/STOP/PAUSE button.
- If the display shows E EO or E E1 after pressing the START/STOP/PAUSE button it is
necessary to take the device to a service centre.
- If there has been a power failure during the operation, the device will remember its
setting for 30 minutes. If the power failure is longer than 30 minutes, the process will not
be renewed. It is necessary to turn the bread maker on again. This can be done only
if the interruption of the program took place later than in the kneading stage. It is then
possible to continue by setting an individual program (erase working cycles that have
already been finished). If the dough was in the last stage of rising and the power failure
lasts for a longer period of time, the dough can not be used and it is necessary to begin
from the start with new ingredients.
- Beware that the bread maker does not have top heating (for safety reasons) therefore
the crust on the top part of the bread is not as dark as the bottom part and sides.
PAUSE function
To pause the operation (e.g. for easy adding of ingredients). The operation of the device
will pause (the display will show ashing time which remains till the end of the program) but
the setting will be saved in the memory. The pause function can be activated by pressing
the START/STOP/PAUSE button. Pressing the button again will renew the operation.
Notice
We recommend pausing the operation only for a short time, max. up to 5 minutes. If the
program were paused for longer, it may endanger the rising of the dough and the result of
baking.
V. PREPARATION FOR USE AND PROGRESS OF BAKING
Unpack the bread baker and accessories. Remove all adhesive foils, stickers or paper from
the appliance. Before rst use, wash the parts in contact with foods in hot water with
a detergent, rinse properly with fresh water and wipe or let it dry.
To Next Page
