eta STORMY User Manual

V. REMOVING THE DUST CONTAINER AND FILTERS
Caution
– Maximum suction performance can be achieved when the filters are clean and the
dustbag is empty.
– Every time you empty the dust container, we recommend that you also clean the filters.
– When you are vacuuming very fine dust, the filter pores might get clogged. This
reduces the air flow and the suction performance deteriorates. In such a case, the
filters need to be cleaned even though the container is not full yet.
DUST CONTAINER REMOVAL
When taking out the dust container B follow the procedure indicated in Fig. 4. Dispose of
dirt contained in the dust container with regular household waste. An emptied and cleaned
container is to be put back into the vacuum cleaner in reverse order.
INPUT FILTER REPLACEMENT
To remove the input filter, follow the procedure indicated in Fig. 4. To fit a new input filter
in the vacuum cleaner, proceed in reverse order.
OUTPUT FILTER REPLACEMENT
To remove the input filter, follow the procedure indicated in Fig. 3. To fit a new output filter
in the vacuum cleaner, proceed in reverse order.
VI. CLEANING AND MAINTENANCE
Treat surface of the appliance with a soft and damp cloth, do not use coarse and aggressive
detergents!
Accessories
After any vacuuming it is recommended to check visually the brushes or collectors
for possible impurities. If there are some impurities, remove them.
Dust container
Clean the dust container with a wet cloth. Allow all the parts to dry out properly before re-use.
Input and output lters
Rinse the lter B4, B5, B7 under running water. Allow them to dry out properly before their
re-use. Shake out the HEPA lter A11 gently, or blow it out. If the HEPA lter is very dirty,
you can rinse it under running lukewarm water. Allow it to dry out properly.
Caution
– Do not clean the HEPA filter or the other filters with any aggressive washing
or cleaning detergents or hot water.
– In order to maintain the filtering parameters of the HEPA filter, we recommend that
you use a dry method of cleaning.
– If you clean the HEPA filter with water, its filtration properties will deteriorate. The filter
cannot be washed more than three times. After that, a new filter needs to be purchased.
– If the filters are not cleaned or replaced, it might result in damaging the vacuum cleaner!
GB
21 / 39

eta STORMY Specifications

General

Brand	eta
Model	STORMY
Category	Vacuum Cleaner
Language	English