To Previous Page

5. If you have been experiencing boot issues with your console, please reseat the RAM, check internal cables for

any loose connectors, and (if necessary) dust out the inside of the console (compressed air works very well).

6. After verifying repaired console is functional, reverse these steps for re-assembly.

NOTE: The (3) larger screws go on the front edge. If the (4) small screws are not threading in, try setting the

console vertically on its side with the tough screw location on top. It may help to keep the screws loose until all

of the screws are threaded in place.

https://support.etcconnect.com/ETC/Consoles/Eos_Family/Element/How_To_Open_An_Element

Updated: Fri, 17 Sep 2021 16:18:11 GMT

Other manuals for ETC Element

Questions and Answers:

Need help?

Do you have a question about the ETC Element and is the answer not in the manual?

General

Ethernet	Yes
Ethernet Ports	1
Operating System	Embedded Linux
Type	Lighting Console
MIDI	Yes
Outputs	Ethernet (sACN, Art-Net)
Control Protocol	sACN
Power Supply	Internal
Faders	40 Submaster/Playback Faders (Element 60), 20 Submaster/Playback Faders (Element 40)
Submasters	40 (Element 60), 20 (Element 40)