2 CEM+ Sensor Rack Retrofit Manual
Safety
Please note the following safety warnings before use:
• Disconnect power from the racks before all maintenance.
Overview of this Manual
Reference this manual throughout the retrofit procedure.
• Preparation, page 5 - before you open the rack.
• Remove the Old, page 5 - labeling and remove the existing equipment.
• Install the New Backplane, page 9 - transfer the wiring and install new components.
• Change out the AF Cards (if present), page 10 - remove the existing Advanced Feature
cards and install the new ones.
• Change out the Beacon PCB, page 10 - replace the beacon pcb with the new one.
• Verify the Retrofit, page 11 - put the dimmers back in the rack and power up the rack.
• Configure the CEM+, page 11 - put a configuration in the CEM+.
• Finishing Touches, page 11 - replace rack stickers and the acrylic beacon in the door.
• Quick Reference Sheet, page 13 - is an illustrated overview of the retrofit procedure.
When viewing this document in electronic form (pdf file) with Adobe Acrobat Reader, blue
italicized text followed by a page number such as “Overview of this Manual, page 2” is a
link within the document. If you click on the link, it will jump to that section or topic.
WARNING:
Dimmer racks without an accessible power disconnect device cannot be
serviced safely.
To Next Page
Loading...