31
Consult the table below if your mower has a problem. If the problem encountered is not included in the table below or if the remedy proposed
does not solve the problem, contact your dealer, who has the skills and equipment necessary to deal with it.
MALFUNCTION PROBABLE CAUSES REMEDIES
No lights come on on the dashboard Fuse n°3 (section 9•2•1) Replace the fuse
Faulty battery connection Connect the battery correctly (section 10•3)
All the lights come on, but the starter does not
run
The safety conditions for starting are not met See section 7•2
All the lights come on, the engine does not
start
Not enough fuel Fill up with fuel
Insufficient battery charge Recharge the battery (section 10•3•2)
Check the courant of charge
The engine is running, but stalls when the
operator presses on the drive pedal
The safety conditions for movement are not
met
See section 7•2
The cutting system does not engage The safety conditions for mowing are not met See section 7•2
The battery charge warning light stays on
after the engine starts
Faulty battery charge circuit Contact your dealer
The warning buzzer and the engine tempera-
ture warning light come on
The intermediate engine cover or radiator
grilles are obstructed
Clean the radiator grilles (section 10•1•6)
Lack of coolant Top up and check for escapes
The hydraulic oil temperature comes on Temperature of the hydraulic oil too high Stop the engine and contact your dealer
The engine oil pressure warning light is on
(after the engine starts)
Insufficient oil level Top up with oil
The light authorising the movement of the
machine is off
Safety contactors See section 7•2
The light authorising the starting of the blades
is off
Safety contactors See section 7•2
13• MALFUNCTIONS AND THEIR REMEDIES
To Next Page
Loading...
