KL6600
There is a short circuit place “light” to see whether the control lamp hold synchronizer inside
or not.
Ⅳ).The operation of “
AUX
”
“
AUX
” is to control an additional load to be ON/OFF .And the additional load can be used
for DVD/TV or others, and its MAX power is 1KW/230V.
Ⅴ) Automatically anti-freeze (It is effective when working with heater)
When the water temperature is below 44℉/6.7℃ or much lower, anti-freeze is automatically
starting, all the pumps and blower work for 30 seconds and then turn off. The heater and
circulating pumps turn on. The panel shows “ ”
When the water temperature is reaching 46℉/7.8℃ or above, all the heaters and circulating
pumps stop working.
Ⅵ). The operation of auto moisturizing (B3=ON):
1. When the water level pin detects that there is no water, LCD shows “ ”, then moisturizing
function would start auto and at this time, LCD shows “ ”.
2. When it doesn’t reach the water level pin in 30 minutes, (maybe there is no tap water), the
moisturizing solenoid valve would temporary close, then LCD shows “ ”(water flow in
pause), after 30 minutes, the moisturizing solenoid valve would start again. In this way, after it
repeats to fill the water, the “ ” will disappear.
***Additional Remarks***
1. There is a water level detection and a water flow detection inside the heater, which are used for
controlling the heater and the pump.
2. Water level pin is only for auto moisturizing.
To Next Page
Loading...
Need help?
General
