What to do if my ETNA AKI586ZT is not working and nothing appears in the display?
If your ETNA Hob is not working and the display is blank, it's likely due to a power supply issue. Check the fuses or the electric switch to ensure proper connection.
What does it mean when Flash symbol appears in the display of my ETNA AKI586ZT Hob?
The flash symbol on your ETNA Hob display indicates that either you've pressed two or more keys simultaneously, or the control panel is dirty or wet. Avoid pressing multiple keys at once, and ensure the control panel is clean and dry.
Why does error code U400 and/or continuous beep appear on my ETNA Hob?
Error code U400 and/or a continuous beep on your ETNA Hob suggests the appliance has been connected incorrectly, or the mains voltage is too high. It is recommended to have your connection changed.
What to do if a cooking zone suddenly stops working and I hear a signal on my ETNA Hob?
If a cooking zone on your ETNA Hob stops and you hear a signal, the preset time has likely ended. Touch the plus (+) key to stop the beeping.
Why does 'n' appear in the display and some touch controls are not working on my ETNA Hob?
If 'n' is displayed and some touch controls aren't working on your ETNA Hob, the bridge function is likely activated. Deactivate the bridge function to restore normal operation.
What to do if I see code G on downdraft display (alternately with the selected power) of my ETNA Hob?
If you see code G on the downdraft display of your ETNA Hob (alternating with the selected power), it means the grease filter has been operating for 30 hours. Clean the grease filter and use the downdraft clean function.
What to do if I see code S on downdraft display (alternately with the selected power) of my ETNA AKI586ZT Hob?
If code S is displayed (alternating with the selected power) on your ETNA Hob's downdraft, it indicates the carbon filter has been operating for 120 hours. Replace the carbon filter and use the downdraft clean function.
What does it mean if 'L' appears in the display (from the left zones) of my ETNA Hob?
If 'L' is displayed on the left zones of your ETNA Hob, the Child Lock function is activated. To resolve this, disable the Child Lock function.
What to do if I see Flashing 8 on downdraft display of my ETNA AKI586ZT Hob?
A flashing 8 on the downdraft display of your ETNA Hob indicates excess liquids inside the downdraft interior. Dry and clean the downdraft interior.
Why does a slight smell is noticeable the first few times the ETNA AKI586ZT Hob is used?
A slight smell when using your ETNA Hob for the first few times is normal. This occurs as the new appliance heats up and will disappear after a few uses. Ensure you ventilate the kitchen during this time.
General| Type | Gas Hob |
|---|---|
| Number of cooking zones/burners | 4 |
| Width | 58 cm |
| Material | Stainless Steel |
| Ignition type | Electronic |
| Gas type | Natural Gas |
To Next Page
