EasyManua.ls Logo

ETNA OP270ZT/E02 - Cleaning; Cleaning the Appliance; Removing and Cleaning the Guide Rails

ETNA OP270ZT/E02
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN 15
Cleaning the appliance
Clean your appliance regularly to prevent a build-up of grease and food particles,
especially on interior and exterior surfaces, the door and door gasket.
Clean the exterior surfaces with a soft cloth and soapy warm water.
Wipe afterwards with a clean, damp cloth and dry the surfaces.
Remove splashes and stains on the interior surfaces with a soapy cloth.
Wipe afterwards with a clean, damp cloth and dry the surfaces.
Take care that no water enters the vents.
Never use abrasive cleaning agents or chemical solvents.
Ensure that the door gasket is always clean. This will prevent a build-up of dirt so
that the door can close properly.
Removing and cleaning the guide rails
Use conventional cleaning products to clean the guide rails.
Remove the screw at the bottom of the guide rails.
Grasp the guide rails at the bottom and tilt them towards the middle of the oven.
Remove the guide rails from the holes in the back wall.
B
A
C
CLEANING

Table of Contents

Related product manuals