14
Version: Shows the version of the software on the camera.
Mode button (Position 14 in the overview)
Parking mode button (Position 12 in the overview)
Pressing the Mode button multiple times allows you to switch the function modes in the following sequence:
Video mode – Photo mode – Play mode.
Press the Parking mode button before switching the camera o. The „P symbol“ will be shown in the top right
of the display. After the camera is switched o, it is in Parking mode, see also the „Gravity sensor“ in section
6.5 Functions.
TV mode: Set the television standard that matches your television.
NTSC – PAL
Full light: You can switch the Power-LED on permanently.
Switch o – open (switched on)
Format: The memory card is formatted, all data is lost.
Cancel – Conrm
The standard settings: The factory settings of the camera are restored.
Cancel – Conrm
Stop mode: If the stop mode is activated, the video recording is saved automatically in the
event of an impact (this recording is not deleted automatically). Three levels may
be set for the severity of the impact.
Switch o – 2G (light impact) – 4G – 8G (serious impact)
Camera settings (symbol shows a screwdriver in the top left of the display):
Date/Time: Set the date and time using the cursor buttons and conrm each entry by
pressing the OK button. Press the menu button to exit this menu item.
Automatic switch o: Set whether and when the camera is to switch itself o automatically when in
Standby mode.
Screensaver: Set whether and when the screensaver is to be activated.
Beep: Switch the button sounds on/o
Switch o – open (switched on)
Language settings: Set the menu language and conrm the selected language using the OK
button.
Light frequency: Set the frequency of the power network of your country.
50 Hz – 60 Hz
To Next Page
Loading...