30
Disposal
Environmental note
Local regulations must be observed for the disposal of the
product.
The
packaging should also be sorted by type and
disposed of in the relevant collection containers.
Further
information is available from your communal
disposal point.
Contact
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal
GERMANY
Telefon: +49 (0) 202 - 429283-0
Telefax: +49 (0) 202 - 429283-20
E-mail: info@eal-vertrieb.com
Maintenance
Before each trip, check the bicycle carrier for wear.
Defective metal parts and tightening straps in particular
must be replaced.
Please refer to our customer service for the replacement
of parts.
Any modification of original parts and materials or the
c
onstruction of bicycle carrier can adversely affect its
safety and serviceability.
The steel parts of the bicycle carrier are protected at the
factory against corrosion using a powder coating. If this
paint coating
is damaged, please have the damage
repaired professionally
as soon as possible.
Under normal conditions, the bicycle carrier only requires
cleaning and is otherwise maintenance-free.
Adjustment
of the quick release fastener
Only perform this maintenance operation if the bicycle
carrier cannot be mounted firmly to the trailer coupling, as
described in the chapter "Mounting".
• Remove the bicycle carrier from the trailer coupling as
described in "Dismantling".
• Remove the dust c
ap.
•
Loosen
the locking nut slightly, as shown in the
illustration.
•
Screw in the setting screw one quarter of a turn.
• Tighten the locking nut.
• Check whether the carrier is now firmly seated on the
trailer coupling as described in "Mounting". If not,
repeat steps described above.
Maintenance / Disposal / Contact
To Next Page
Loading...
Need help?
General
