eufy Security 2K - Setting Up the System; System Configuration; Finding a Mounting Spot; Location and Height Selection

05
English English
06
STEP 2 SETTING UP THE SYSTEM
Set up the System
1. Download the Eufy Security App from the App Store or Google Play Store and install the App
on your phone.
2. Log into the Eufy Security App. Add your video doorbell (Wired) and scan the QR code for
later installation process. QR code can be found on the back of the video doorbell and at the
rear of the documentation box.
Download EufySecurity App from App
Store or Google Play.
Register or log into your EufySecurity
account.
Add the doorbell and scan this code.
3. Follow the on-screen instructions to connect the video doorbell to your home Wi-Fi, and
complete the setup of the video doorbell. Then you can view live streams on the Eufy Security
app. When you press the doorbell button, the provided electrical chime will sound a ringtone.
Note:
If you want to share your video doorbell to your family members and let them
operate the video doorbell via the Eufy Security App, go to Family & Guest from the App’s
side menu and follow the on-screen instructions to share your video doorbell.
STEP 3 FINDING A SPOT FOR MOUNTING
Select Location and Height
1. Take the video doorbell outdoors with the power cord connected to it. It is safe to carry it
around as the output is low voltage(19V DC).
2. Try to nd a location at your front door where you can get an ideal eld of view on live
stream. This is the location where you will mount the video doorbell. The recommended
height for mounting is 48” (1.2 m) from the ground.
If you want to place the doorbell close to a side wall, make sure the wall doesn't show up in
the eld of view. Installing the doorbell too close to a side wall will reect IR light and make
night vision blurry.
1.76m(5’9”)
1.2m (48")
0.3m
(12")
1m
(40")
3. Place the Screw Hole Positioning Card against the wall to mark the location for the power
cord to run through the wall. Position the hole for the power cord to line up with the bottom
half of the Positioning Card’s square hole. Make sure this is where the wire will come out of.