eufy Security HomeBase 2 - Mounting on Hard Materials

14
English English
15
Mount the Doorbell on Surfaces Made Out of Hard
Materials
1. If you’re mounting the doorbell on a surface made out of hard materials, like brick,
concrete, stucco, drill 2 holes through the Screw Hole Positioning Card with a
15/64”(6mm) drill bit.
2. Insert the provided anchors, and then use the provided long screws to secure the
Mounting Bracket on the wall.
What is required: Power Drill, 15/64”(6 mm) Drill Bit, Mounting Bracket, 15°
Mounting Wedge (Optional), Screw Packs
Power Drill
(not provided)
15/64”(6 mm) Drill Bit
Mounting Bracket
(Attached to 15° Mounting
Wedge)
15° Mounting
Wedge (Optional)
Screw Packs (Spare screws
and anchors are included.)
1
2 2
Wall
Wall
Mounting
Bracket
Mounting
Wedge
Mounting
Bracket
Without 15° Mounting Wedge With 15° Mounting Wedge