eufy Security T8203 - Wire Connection to Doorbell

9 10
Step 7
Lead the two doorbell wires through the central square hole on the bracket before start
mounting.
Insert the two screws provided through the screw holes or through the 15° mounting
wedge(Install the mounting bracket to the 15° mounting wedge in prior), and fasten the
screws tightly.
What are required: Mounting Bracket / Screw Packs / 15° Mounting Wedge(Optional) /
Phillips-Head Screwdriver
Step 8
Connect the wires to the two terminals at the back of the doorbell, then tighten the
terminal screws. Wire can connect to any terminal as the electric current is alternating
current.
Note: To prevent short-circuit, make sure the wires are not touching each other after
connecting them to the terminals. If the wires are too short, use the extension wires and
wire nuts provided to make them longer. Use electrical wiring tape to secure the connection
if the wall doesn't have space for wire nuts.
What are required: Extension Wires and Wire Nuts (Optional) / Video doorbell / Philips-
Head Screwdriver
eufy Video Doorbell Dual (Wired)
Model: T8203