English
13
Mount the Doorbell on Surfaces Made Out of
Hard Materials
1. If you’re mounting the doorbell on a surface made out of hard materials,
like brick, concrete, stucco, drill 2 holes through the screw hold positioning
card with a 15/64”(6mm) drill bit.
2. Insert the provided anchors, and then use the provided long screws to
secure the mounting bracket on the wall.
What you need: Power Drill, 15/64”(6 mm) Drill Bit, Mounting Bracket,
15° Mounting Wedge (Optional), Screw Packs
Power Drill
(not provided)
15/64”(6 mm) Drill
Bit
Mounting Bracket
(Attached to 15°
Mounting Wedge)
15° Mounting
Wedge (Optional)
Screw Packs (Spare screws
and anchors are included.)
1
To Next Page
Loading...
