26   
English
NOTICE
13
 
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the 
following two conditions: (1) this device may not cause harmful interference, and 
(2) this device must accept any interference received, including interference that 
may cause undesired operation. 
Warning:
 Changes or modifications not expressly approved by the party 
responsible for compliance could void the user's authority to operate the 
equipment. 
Note: 
This equipment has been tested and found to comply with the limits 
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits 
are designed to provide reasonable protection against harmful interference in a 
residential installation. 
This equipment generates uses and can radiate radio frequency energy and, if 
not installed and used in accordance with the instructions, may cause harmful 
interference to radio communications. However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does 
cause harmful interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user is encouraged to 
try to correct the interference by one or more of the following measures: (1) 
Reorient or relocate the receiving antenna. (2) Increase the separation between 
the equipment and receiver. (3) Connect the equipment into an outlet on a 
circuit different from that to which the receiver is connected. (4) Consult the 
dealer or an experienced radio/TV technician for help. 
FCC Radio Frequency Exposure Statement 
The device has been evaluated to meet general RF exposure requirements. 
The device can be used in xed/mobile exposure condition. The min separation 
distance is 20cm.