Recharging the Battery
1. Insert the detaching pin into the pin hole on the top of the doorbell, then lift the top for removal.
2. Repeat steps in "CHARGING THE BATTERY PACK".
You can purchase an extra battery pack for quick replacement.
DOORBELL MOUNTING (Wire Powered)
Check the Doorbell Wires
1. Ring the existing doorbell to check if it is working. If it doesn't ring, your doorbell wires may be defective. Power on the
doorbell by the built-in battery or consult an electrician to repair the wires.
2. Shut o the power at the circuit breaker. Turn the lights on and o to make sure the electricity in your home is properly
shut o.
OFF
Always be careful when handling wires. If you're not comfortable installing it yourself, have a qualified electrician to do
it.
Detach the Existing Doorbell Button
If you already have existing doorbell wiring:
1. Remove the existing doorbell button with a Phillips-head screwdriver (not provided).
2. Pull the two wires out carefully when removing the existing doorbell. Straighten the wire ends if necessary.
To Next Page
Loading...
