3. Align the mounting plate with the threaded screw receptacles of the exterior assembly. Tightly fasten the screws in place.
Set the screws with your hands, then use a screwdriver to secure them.
I
Inside
Step 5. Install Interior Assembly
1. Rotate the interior assembly handle to the left or right. Then lock the screw into the corresponding screw hole.
·
The handle must be horizontal when you tighten the screw.
·
Tighten the screw all the way down. Otherwise, the handle may get stuck.
·
Make sure that the interior handle direction is the same as the exterior one.
To Next Page
Loading...
