Euhomy RF-H - Installation Requirements and Instructions; Door Reversing Procedure

Door Reversing (Optional)
1.Ensure that the unit is unplugged before starting door reversal.
2.Remove the 2 plug buttons on the left side on the top of the cabinet.
3.Remove the plastic hinge cover by prying from the back and pulling
forward.
4.Remove the 2 screws from the top hinge.
5.Lift the freezer door up and off the center hinge (right side). Set the
freezer door on a non-scratching surface with the outside facing
upwards.
6.Open the fresh food door and remove the center hinge by removing
the 2 screws. Lift the hinge to remove.
7.Lift the fresh food door off of the bottom hinge. Set the fresh food
door on a non-scratching surface with the outside facing upwards.
8.Lay the refrigerator on its back to get access to the bottom hinge.
9.Remove the bottom hinge by removing the 3 screws. Lift the hinge to
remove.
10.Remove the hinge pin on the bottom hinge and reinstall on the
opposite side of the hinge.
Follow all the steps when reversing the door swing. Failure to follow these instructions, leaving out
parts, or overtightening screws, can lead to the door falling off and result in injury and property damage.
WARNING
Plug
Buttons
Plug
Buttons
Center
Hinge
Center
Hinge
Bottom
Hinge
Hinge
Pin
Hinge
Pin
Bottom
Hinge
Hinge and
Cover
Hinge and
Cover
Turn
Turn
Installation Requirements
07