What to do if my Euhomy TWW-35 Refrigerator displays code F1?
If the Euhomy Refrigerator displays code F1, it means there's low voltage to the fridge. To solve this, adjust the battery protection from High to Medium or from Medium to Low.
Why my Euhomy TWW-35 Refrigerator does not work?
If your Euhomy Refrigerator isn't working, check the following: * Ensure the switch is turned on. * Make sure the plug is fully inserted into the socket. * Check if the fuse has burned out. * Verify that the power supply is functioning correctly. * Be aware that frequent on-off switching may cause a start delay for the compressor.
Why are Euhomy Refrigerator compartments too warm?
If the Euhomy Refrigerator compartments are too warm, it might be because the door is opened frequently, a large amount of warm or hot food was recently stored, or the refrigerator has been disconnected for a long time.
What does code F2 mean on my Euhomy TWW-35?
If the Euhomy Refrigerator displays code F2, it indicates the condenser fan is overloaded. Disconnect power to the fridge for 5 minutes and restart it. If the code reappears, contact the manufacturer for service.
What does code F3 mean on my Euhomy Refrigerator?
If the Euhomy Refrigerator displays code F3, it means the compressor starts too frequently. Disconnect the power to the fridge for 5 minutes and restart it. If the code shows again, contact the manufacturer for service.
What does code F4 mean on my Euhomy TWW-35 Refrigerator?
If the Euhomy Refrigerator displays code F4, it indicates the compressor is not kicking in. Disconnect the power to the fridge for 5 minutes and restart it. If the code reappears, contact the manufacturer for service.
What does code F5 mean on my Euhomy Refrigerator?
If the Euhomy Refrigerator displays code F5, it means there is overheating of the compressor and electronics. Disconnect power to the fridge for 5 minutes and restart it. If the code shows again, contact the manufacturer for service.
What does code redisplayed mean on my Euhomy TWW-35?
If the Euhomy Refrigerator displays code redisplayed, it means that no parameter can be detected by the controller. Disconnect power to the fridge for 5 minutes and restart it. If the code shows again, contact the manufacturer for service.
How to stop food from freezing in my Euhomy TWW-35 Refrigerator?
If food is freezing in your Euhomy Refrigerator, the temperature might be set too low.
What to do if my Euhomy TWW-35 displays code F7 or F8?
If the Euhomy Refrigerator displays code F7 or F8, it means the temperature sensor is faulty. Contact the manufacturer for service.
Procedures for cleaning the appliance, emphasizing safety precautions like unplugging.
Guidelines for storing the appliance when not in use, including preparation and environmental recommendations.
Instructions for defrosting the appliance to maintain cooling efficiency, addressing frost formation issues.
General| Refrigerant | R600a |
|---|---|
| Capacity | 3.5 cubic feet |
| Shelving | Adjustable |
| Door | Reversible |
| Voltage | 115V |
| Cooling Method | Compressor |
To Next Page
