fig 1A
fig 4A
Tent Set Up: Tent, Poles and Stakes
1. Unpack and separate the components. Unfold the tent with the oor
on the ground. Do not stake the tent down yet. However, when windy,
stake down one corner into the wind. See g 1A.
2. Join two shock-corded poles together. Try to prevent pole sections from
snapping together, as this can damage the pole ends. Make certain each
insert (male end) has seated rmly into each plain
end (female).
3. Lay the poles across the tent in an X pattern.
Then insert the post of each pole into a grommet
on the stake out webs. Make sure the side release
buckle on the web points up.
See g 2A and 3A.
Section A
4. At the opposite
end, arch each pole
and seat its post
into the stake out
web grommet to
maintain tension.
See g 4A.
fig 3A
fig 2A
To Next Page
Loading...
