Eureka Combat - Combat Tent Pitching Instructions

E
D
A
C
B
F
Pole sleeve
Follow seams
where poles
cross
A
E
C
B
D
F
1. Lay the tent body out on the ground. Assemble the poles. Make
sure each rod is fully inserted into the next rod. Do not let the rods
snap together.
2. Open the doors of the tent. Do not stake the tent down yet. In
windy conditions, stake down the corner that faces into the wind.
3. Start at a corner and slide a pole through a sleeve. Follow the
seam to the next sleeve and slide the pole through. Continue until
you reach the other side of the tent. Be careful wherever seams
cross.
4. Repeat with second and third poles. One pole should run from A
to B, a second from C to D and the third from E to F.
5. Place the pole posts into the grommets at the corners of the tent
in the following order: A to B, C to D and E to F.
Pitching Instructions: