Eureka NER E10s - Quick Assembly; Installation of Side Brushes; Filter Installation; Setting Up Self-Emptying Base

Remove excess clutter and cables on the floor before cleaning.
Setting up self-emptying base
1.
2.
3.
Place the self-emptying base flat against the wall on a level surface.
If there is any charging base for other robotic vacuum cleaners in the
room, please put it away before use of our self-emptying base to avoid
mismatching.
Place the self-emptying base in an area covered with wireless network
signal to ensure stable network connection of the robotic vacuum and
proper function of the App.
Store the excess cords into the slot at the back of the charging base
to avoid aecting the proper function of the robotic vacuum.
Plug the power cord into a power outlet. Switch the power switch to
“I” position to turn on the base.
Installation of side brushes
1.
2.
Quick Assembly
Filter installation
Robotic Vacuum comes with filter installed. Before use, ensure the filter is
securely in place. If not, remove dustbin from robotic vacuum, pull up lid of
dustbin and make sure filter is snapped into place. Ensure dustbin lid and
bottom latch are securely closed and place back dustbin onto robotic
vacuum.
When using the mopping function, open the tank lid, fill the water tank
with cold water, and securely close the lid.
10 Eureka Customer Service HELPLINE 1-800-282-2886
Turn the main unit over. Attach the side brush to its color-matched
post and press down until they fit into place.
To remove the side brush, grab the rubber-coated legs of the side
brush with both hands and pull it out.
≥ 5 ft (1.5m)
≥ 1.5 ft (0.5m)
≥ 1.5 ft (0.5m)
Water Inlet/Outlet
WARNING