Eureka NER E10s - Charging

1. Avoid placing the robotic vacuum and the base under direct sunlight.
2. Be sure to keep the charging area dry.
NOTES
NOTES
Charging
www.eureka.com
11
Press and hold " " for 3 seconds to power on the robotic vacuum.
After the power indicator turns on, press the recharging button or
manually put the robotic vacuum back into the self-emptying base
for charging, as shown. We recommend you charge the robotic vacuum
for at least 6 hours before using it for the first time.
o stable light o
1) Robotic Vacuum is in standby mode, or
2) Cleaning in progress, or
3) Robotic Vacuum is fully charged.
stable light stable light
battery level ≥ 20%, robotic vacuum has
finished its mission and is going
to recharge
o
Status
stable light flash quickly
battery level < 20%, robotic vacuum is
going to recharge
o
flash slowly o Robotic Vacuum is chargingo
flash quickly o
Error has occurred, see
"Troubleshooting".
o
Indicator Light
o o
Robotic Vacuum is in sleep mode or
turned o.
o
When the battery level is too low, the robotic vacuum cannot be turned on. Please manually put the robotic
vacuum onto the charging base.
The robotic vacuum will not be turned o when placed on the charging base. To turn the battery o, remove the
robotic vacuum from the base, press and hold for 3s to shut it down. All indicators will be turned o.
To ensure the optimal performance of the lithium-ion battery, please keep the robotic vacuum charged.
If you manually put the robotic vacuum into the base, ensure that the charging contacts of both the robotic
vacuum and the base are connected.
For long-term storage, remove the robotic vacuum from the base, turn it o and store it in a cool, dry place. If the
robotic vacuum is not used for more than 3 months, allow it to get charged for at least 12 hours before using. To
preserve the battery lifespan, we suggest you fully charge the battery at least once every six months.
1.
2.
3.
4.
5.