Eureka NER E10s - Page 14

Briefly Press " " to start/pause/resume cleaning or use your App to control.
Start / Pause / Resume
The robotic vacuum will enter sleep mode when it is in standby mode for more than 10 minutes. In sleep mode,
press any key to wake up the robotic vacuum.
Do not immerse the robotic vacuum in water. Doing so may damage the equipment, causing short-circuit or
current leakage.
1.
2.
NOTES
How to use your robotic vacuum
12
Eureka Customer Service HELPLINE 1-800-282-2886
Operation
Short Press
Start/pause/resume Return to the base Start spot cleaning
Shut down
/
Enter the network pairing state
Press and
hold for 3s
Button
SPOT Cleaning
When the robotic vacuum is in standby/pause mode, press " " to start spot cleaning. The robotic vacuum will
begin to clean an area of one square meter centered on itself. After spot cleaning, the robotic vacuum will
automatically return to the charging base to recharge.
Note that starting the spot cleaning mode will automatically stop the current cleaning cycle.
1.0m 1.0m
1.0m 1.0m
Self-Emptying Function
After cleaning, the robotic vacuum will return to the charging base and automatically begin self-emptying.
Press the recharging button (the recharge interval between two times should be longer than 5 minutes) to trigger
self-emptying.
Select manual self-emptying function on the App. Avoid manual self-emptying frequently.
1.
2.
3.
Recharge
① When the robotic vacuum is in standby mode, press " " and the robotic vacuum will start recharging.
② When the robotic vacuum is in cleaning process, pressing " " can stop cleaning, and then press " " can
start recharging.
Under special circumstances (such as power depletion, robotic vacuum jamming, etc.), the robotic vacuum may
not be able to recharge automatically. Please manually place the robotic vacuum back to the charging base.
Status Indicators of Self-Emptying Base
White light flashes quickly
Indicator Light Status
Self-emptying base is powered o.
Self-emptying base is powered on.
The air duct of the dust cup may be clogged.
Please check and empty the dust cup in time.
Self-emptying is in progress.
O
Self-emptying base is in sleep mode.
White light stays on
White light flashes slowly