20
4.7.8 Auxiliary Heating Function Setting
Under on status, after entering into user function page, press “∧” or “∨” button to
select auxiliary heating function and press “＜” or “＞” button to turn on or turn off
this function with auto saving.
Note：
This function can be set only in heating mode.
4.7.9 Dry Function Setting
Under on status, after entering into user function page, press “∧” or “∨” button to
select dry function and press “＜” or “＞” button to turn on or turn off this function
with auto saving.
Note：
This function can be set only in cooling and dry mode.
4.7.10 Filter Clean Reminder Setting
After entering into user function page, press “∧” or “∨” button to select filter clean
function and press “＜” or “＞” button to turn on or turn off this function. Press
“MENU/OK” button to enter the setting page of filter clean reminder function.
After entering the setting page of filter clean reminder function, press “∧” or “∨”
button to select pollution level and then press “＜” or “＞” button to set pollution
level; press “∧” or “∨” button to select accumulating time setting and then press “＜”
or “＞” button to set required time. Once setting is finished, press “MENU/OK”
button to save the setting.
When level 1 is selected, the adjusting range of accumulating operating time is
5,500~10,000 hours, with 500 hours in each increase or decrease.
When level 2 is selected, the adjusting range of accumulating operating time is
1,400~5,000 hours, with 400 hours in each increase or decrease.
When level 3 is selected, the adjusting range of accumulating operating time is
100~1,000 hours, with 100 hours in each increase or decrease.
To Next Page
Loading...
Need help?
General