3
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | info@tempo.org
Important Safety Instructions
READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
Read this manual thoroughly before first use, even if you are familiar with
this type of product. The safety precautions enclosed herein reduce the risk
of fire, electric shock and injury when correctly adhered to. Make sure you
understand all instructions and warnings. Keep the manual in a safe place for
future reference, along with any warranty information, your purchase receipt
and packaging. If you sell or transfer ownership of this product, please
pass on these instructions to the new owner. Always follow basic safety
precautions and accident prevention measures when using an electrical
appliance, including the following:
Electrical safety and cord handling
• Voltage: Before plugging in the heater, make sure your outlet voltage and
circuit frequency correspond to the voltage stated on the rating label.
• Electrical circuit: Always plug this heater into a separate wall outlet
socket. Use a safe socket with an earthed connection. To ensure you do
not overload the circuit, do not operate another high-wattage product on
the same circuit.
• Connection: To insert the plug, grasp it firmly and guide it into the outlet.
• WARNING! No adaptor, no extension cord: Do not use the heater with
a power board, double adaptor or extension cord, as these may overheat
and create a fire risk.
• Protect the power cord:
– Do not operate the heater with the cord coiled up; always fully unwind.
– Do not twist or kink the cord or let it touch heated surfaces.
– Do not put any stress on the cord where it connects to the product.
– Never pull/carry the heater by the cord.
– Arrange the cord away from any traffic areas so no one will trip over it.
– Do not run the cord under carpeting or cover it with rugs, runners, etc.
• WARNING! To reduce the risk of fire, electric shock or injury:
– Never touch the heater with wet or damp hands or feet.
– Do not use the heater if any part of it has become wet. Immediately call a
qualified service technician to inspect the heater and replace any part of
the electrical system that has got wet.
– Never spill liquid into the heater; never immerse the cord, plug or any part
of the appliance in water or other liquids.
– Do not reach for an appliance that has fallen into water. Switch off and
unplug immediately.
To Next Page
Loading...
