14
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | info@tempo.org
Operating Instructions
Using the flame effect heater
Before switching on your flame effect heater for the first time, check it again to
be sure it is fully assembled and did not get damaged during wall-mounting or
base assembly.
The appliance can be operated either manually (by the switches located on the
top right hand side of the heater) or remotely (by the supplied remote control).
Pressing any button will be acknowledged with a short beep sound, which
indicates that the command has been received.
Connection
Make sure the POWER rocker switch is in the OFF [ O ] position, then plug
the heater into an appropriate electrical outlet and switch on power to the
outlet. Always use a separate socket that has no other high wattage appliances
connected at the same time – do not plug it into a power board or socket
adaptor; do not use an extension cord.
First use
When turning on the heater for the first time, it is normal for the heater to emit
a ‘new heater’ smell, which will quickly pass. This is no cause for concern.
Ensure good ventilation.
Manual operation
Use the switches at the top right hand side of the heater to operate the
appliance manually.
• Standby: Set the POWER rocker switch to the ON [ I ] position to set the
heater into standby mode.
• Switch on: Press the ON/OFF [ 0/I ] button once to switch the appliance on
in flame effect mode (no heat).
• Dimmer: Press and hold the ON/OFF [ 0/I ] button for a few seconds to
activate the dimmer mode. Hold the button down until the flame effect has
the desired brightness level, then release.
• Low heat: Press the [ 900W ] button once to add low heat to the flame
effect; press the button again to switch off the heat.
• High heat: Press the [ 1800W ] button once to add high heat to the flame
effect; press the button again to switch off the heat.
• Standby/switch off: Press the ON/OFF [ 0/I ] button to set the appliance
back into standby mode. Set the POWER rocker switch to the OFF [ O ]
position to disconnect the appliance from the power supply.
To Next Page
Loading...
