Need help?Do you have a question about the Eurotherm 2116 and is the answer not in the manual?
General| Control Type | PID |
|---|---|
| Display | LED |
| Mounting | Panel Mount |
| Input Type | Thermocouple, RTD, mA |
| Output Type | Relay, SSR, mA |
| Operating Temperature | 0 to 50°C |
| Communication | RS485 |
Instructions for installing the controller into a panel cutout, securing it with retaining clips, and removing protective covers.
Procedure for safely removing and reinserting the controller from its sleeve while maintaining sealing.
Guidance on the minimum required spacing between controllers for proper ventilation and operation.
Specifies the acceptable wire sizes for screw terminals and tightening torque recommendations.
Illustrates the typical wiring connections for the controller, including power, sensor, and output.
Step-by-step guide on how to change the desired temperature setpoint using the controller's buttons.
Instructions on how to cycle through and view the available temperature display units (°C, °F, K).
Procedure for acknowledging active alarms and resetting latched alarms.
Explanation of various alarm messages displayed by the controller and their meanings.
How to check the current heating or cooling energy demanded by the controller.
Method for navigating through and accessing various parameter lists for configuration.
Guide to setting the trip levels for the controller's alarm functions.
Overview of the various parameter lists available for controller configuration and tuning.
Detailed tables outlining controller parameters, their ranges, and default settings.
Instructions for managing parameter visibility and accessibility for operators.
Guide on how to use the controller's built-in timer functions and modes.
Methods for initiating, controlling, and resetting the timer function.
Steps to access different configuration levels using passwords.
Settings for display units, decimal places, control type, and control action.
Options for selecting sensor input type, thermocouple types, and linear input scaling.
Configuration of internal soft alarms, their types (latching/non-latching), and blocking behavior.
Configuring relay and logic I/O for outputs like heating, cooling, alarms, or inputs like timer control.
Details on the different password levels for accessing configuration settings.
Procedure to exit the configuration mode and return to the operator level.
List and explanation of diagnostic alarm messages indicating potential hardware or software issues.
Procedure for applying offsets to compensate for sensor errors and system inaccuracies.
Method for automatically tuning PID parameters to optimize process control stability.
Procedure for manually adjusting PID parameters when automatic tuning is unsatisfactory.
To Next Page
