Need help?Do you have a question about the Eurotherm 0216 and is the answer not in the manual?
General| Category | Temperature Controller |
|---|---|
| Control Algorithm | PID |
| Power Supply | 24V AC/DC, 100-240V AC |
| Mounting | Panel Mount |
| Input Type | Thermocouple, RTD |
| Output Type | Relay |
| Alarms | 2 configurable alarms |
| Communication | RS485 |
| Display | LED |
| Dimensions | 48 x 96 mm |
Explains controller display elements: measured value, set point, and timer status.
Details procedures for accessing and leaving the configuration menu.
Procedure for manually switching the output power on or off.
Covers modifying parameters and performing an LED lamp test.
Covers default configuration, parameter security, and password recovery methods.
Provides physical dimensions and cut-out requirements for panel mounting.
Details wiring for Thermocouple (TC) and RTD inputs, including diagrams.
Explains wiring and programming for the logic input feature.
Illustrates wiring for relay and voltage outputs for SSR drive.
Instructions for connecting the instrument to the main power supply.
Explains SH1/CH1 jumper functions for input indication.
Describes pushbutton functions and parameter protection via secret codes.
Guide to entering configuration, modifying parameters, and setting input types.
Assumes configuration; explains display modes for 0316/0216.
Details SMART algorithm operation and how to inhibit control outputs.
Covers set point display/modification and detailed descriptions of timer modes.
Explains alarm reset, soft start, lamp test, and status indicators.
Lists control parameters and general modification procedures.
Explains overrange/underrange display indications and their causes.
Lists error codes, their meanings, and procedures for handling them.
Lists case, protection, dimensions, power, and environmental conditions.
Details input types (TC, RTD, Logic) and control action parameters.
Covers output specifications and the CPI for PC configuration.
Explains the procedure to load factory default parameter values.
Details specific default configuration parameter tables for different models.
Provides fields for recording and managing security codes.
To Next Page
